How to Change a Flat Tyre When You’re on the Side of the Road

How to Change a Flat Tyre When You’re on the Side of the Road

Don’t get stuck with only three working wheels 🚗

No one ever thinks about needing to change a flat tyre…until a flat tyre happens to them.

And sometimes you’ll be able to call a friend or even roadside assistance to help you out.

But if you haven’t got those options, you don’t want to be stuck on the side of the road with a flat tyre.

@studentedge Stuck with a flat tyre and don’t know how to change it? We got you. Check out our tutorial on how to change a flat tyre 🚘 Check out the full tutorial on our YouTube channel! #students #studentlife #flattyre #car #roads #fyp #fup #students #australia #student #carsoftiktok ♬ original sound - Student Edge

What you will need.

  • Jack
  • Lug wrench/wheel brace
  • Fully inflated spare tire
  • Vehicle owner’s manual

You should have all these in your car under your boot compartment.

 

Here’s how to change a flat.

Firstly, make sure your engine is off with the handbrake engaged and put your hazard lights on.

If possible, try and pull your car up to the side of the road or to a safe spot.

  1. Grab your tools and spare tyre from the inside of your boot (usually under the boot).
  2. Check your car’s manual to find the jacking point and place the jack under the car.
  3. Slightly lift the car so the jack is in slight position, and it takes off some of the load.
  4. Loosen the lug nuts (the big screws) while the wheel is still on the ground, just enough to break the tension.
  5. Slowly raise the car until the tyre is just off the ground. You should be able to put a flat hand in between the ground and the tyre.
  6. Unscrew the loosened lug nuts. Keep the lug nuts somewhere safe to prevent them from rolling away.
  7. Take off your flat tyre and wheel it somewhere safe. Preferably lay it flat so it doesn’t roll onto the road or away.
  8. Line up the spare tyre and put it on the car and screw in the lug nuts by hand and tighten them.
  9. Gently lower the car and tighten the lug nuts in a criss cross pattern.
  10. Remove the car jack and put the tools back in your car. And you’re done!

Before you drive across the Nullarbor though, remember that most spare tyres are temporary. You should only drive them for a certain distance and at a certain speed. Check your car manual or the spare tyre itself for more information.

Make sure you call up your mechanic to replace the spare tyre in your car as well in case you have any other car breakdowns in the future.

Good luck and happy driving!

Most Popular

Comments & Feedback

Share your opinion

Emoji cheatsheet    Formatting    Comment guidelines